Parking lifts and car stackers, installed and registered with TSSA
A car stacker turns one parking space into two. In Ontario it is a TSSA-regulated elevating device, and we are a TSSA-registered elevating devices contractor.
5,500–9,000lb
Who parking lifts are for
Condo and rental buildings and parking garages that need more spaces in the same footprint. A stacker is for parking, not service work.
The types
Two-post stackers share columns, so a row takes less width. Scissor stackers like the Autostacker A6S have nothing above the raised platform. Four-post tri-level and double-wide lifts hold more cars. Pit lifts set one car below the floor.
Most stackers are dependent: the lower car moves out before the upper one comes down. Pit lifts give every car independent access.
How ceiling height really works
When the lower car drives out, both cars are inside the clear height at once. So the upper car plus the lower car must fit in the clear height, minus a fixed allowance for the lift. Measure to the lowest beam or obstruction, not the slab above.
- Two-post stackers such as the BendPak PL-6000DC and Omer Bipark: allow about 320 mm, and the 3.32 m post must fit.
- Autostacker A6S scissor stacker: allow about 152 mm.
- Pit lift: allow about 180 mm.
- A pit buys independent access and a clear floor. It does not buy room for taller cars.
TSSA rules for parking lifts
Parking garage lifts are elevating devices under O. Reg. 209/01. Shop vehicle hoists are not. They fall under the Ministry of Labour and O. Reg. 851.
A parking lift needs an engineer-sealed design registration, a TSSA-registered installer, an initial TSSA inspection with a full-load test, a yearly licence, maintenance at least every 12 months and a logbook on site.
What we do
Our own crew installs parking lifts and car stackers and handles the TSSA registration and licensing. We work from your measured clear height and the maker's height formula to show which cars will fit.
What your bay needs
Measure to the lowest thing overhead. Final numbers come from the spec sheet of the exact model.
| Clear height, two-post stacker | Both cars + 320 mm |
|---|---|
| Post height, two-post stacker | 3.32m |
| Clear height, Autostacker A6S | Both cars + 152 mm |
| Clear height, pit lift | Both cars + ~180 mm |
| Slab, BendPak HD-973P | 6.5in |
| Power | Not yet confirmed |
Before install day
- Every parking lift in Ontario needs an engineer-sealed design registration with TSSA and an initial TSSA inspection with a full-load test before use.
- The owner renews the TSSA licence every year, one licence per electrical disconnect. Maintenance by a registered contractor is due at least every 12 months, with a logbook kept on site.
- Measure clear height to the lowest beam, sprinkler or duct, not the slab above.
- In Toronto, the zoning by-law's 2.0 m vertical clearance for parking spaces gives no separate dimensions for stacked spaces. Ask your architect how it applies. Accessible spaces cannot be on stackers.
- A pit lift needs a properly built foundation pit.
- Building permits and electrical work are separate from our install.
Installed price quoted as one number
The lift, installed by our TSSA-registered crew, with TSSA registration and licensing handled. Building permits and electrical work are separate.. Call or send your bay details for a firm figure.
Compared with the alternatives
| Parking lifts and car stackers | Four-post lifts | Two-post lifts | |
|---|---|---|---|
| Best for | Condo and garage parking | Storage and drive-on service | General repair, cars and light trucks |
| Typical capacity | 5,500 to 9,000 lb per platform | 7,000 to 18,000 lb | 7,000 to 12,000 lb |
| Ceiling needed | Both cars plus fixed allowance | Columns plus the car on top | About 12 to 13 ft clearfloor |
| Underbody access | Parking only, not service work | Wheels on runways; jacks free them | Full, wheels hang free |
| Floor space | One space holds two cars | Longest; count the ramps | About 11 to 12 ft wide |
| Anchoring and slab | TSSA-registered install; slab per model | Some freestanding; 4-1/4 in common | Anchored, 4-1/4 in at 10,000 lb |
Models we work with
- BendPak Autostacker A6S6,000 lbA scissor-style stacker that turns one parking space into two. Nothing sits above the raised platform, so the car roof is the highest point.
- BendPak PL-6000DC6,000 lbA two-post parking lift that stacks one car over another. Add-on units share a column, so a row takes less width.
- Omer BIPARK 306,600 lbA two-post parking lift from Italy that stacks two cars. The lower car moves out before the upper car comes down.
- BendPak HD-973PA four-post multi-level lift that stores three cars in one space. Each platform is independent, and it is a tall machine.
- Bron BR-P6000SA two-post pit lift that parks one car below the floor and one above. Either car can come out without moving the other.
- Bron BR-P6000DThe double-width pit lift: two stalls side by side, four cars, and every car comes out without moving another.
Common questions
Are car stackers regulated by TSSA in Ontario?
Yes. Parking garage lifts, including car stackers, are a regulated class of elevating device under O. Reg. 209/01. They need an engineer-sealed design registration, a TSSA-registered installer, an initial TSSA inspection with a full-load test, a licence renewed every year, maintenance at least every 12 months and a logbook on site.
Who can install a parking lift in Ontario?
A TSSA-registered elevating devices contractor. Smart Lifting Systems is one, so our own crew installs parking lifts and car stackers and handles the TSSA registration and licensing.
How much ceiling height do I need for a car stacker?
Add the height of the upper car and the lower car, then add a fixed allowance for the lift: about 320 mm on a two-post stacker, about 152 mm on the Autostacker A6S and about 180 mm on a pit lift. The total has to fit under the lowest beam or obstruction. On a two-post stacker the 3.32 m post must also fit.
Does a pit lift fit taller cars than a regular stacker?
No. With any stacker, both cars sit inside the clear height when the lower car comes out. A pit buys independent access to every car and a clear floor, not extra height.
Can I get the top car down without moving the bottom car?
Not on most stackers. They are dependent, so the lower car moves out first. Pit lifts and some four-post designs give independent access to every car.
Related
Pricing a new lift?
Send your ceiling height and what you work on. You get one price for the lift, delivery and install.