Skip to content
Smart LiftingSYSTEMS

Find the lift your bay can take

Seven quick questions about your bay. You get the lift types that fit, the ones that don't and why, and what to check before you buy.

  1. 01 Ceiling
  2. 02 Slab
  3. 03 Vehicles
  4. 04 Bay width
  5. 05 Power
  6. 06 Your shop
  7. 07 Bays

How high is the ceiling?

Clear height

Floor to the lowest thing over the lift: lights, heaters, sprinkler heads, door tracks. Not the roof deck.

Answer this step to go on. “Not sure” is a fine answer.

Have a lift in mind already? The bay-fit checker measures that one against your bay, and the install cost checklist shows what the job involves. Or compare the lift types side by side.

About the selector

Is this a quote?

No. It narrows down the lift types that suit your bay and flags what could stop an install. A firm quote comes after we confirm the details, and sometimes after a look at the bay.

Do I need exact measurements?

No. Every step has a not sure option. You'll still get a shortlist, plus a list of what to measure before a firm price.

Why does slab thickness matter so much?

Anchored lifts hold on through bolts in the concrete. BendPak publishes a minimum of 4-1/4 in for its 10,000 lb two-posts, 6-1/2 in at 12,000 lb and 8 in at 15,000 to 18,000 lb. Each maker publishes its own figure for each model.

How do I measure ceiling height for a lift?

Measure from the floor to the lowest thing that hangs over where the lift will stand: lights, unit heaters, sprinkler heads, door tracks or ductwork. The roof deck doesn't count if something hangs below it.

Why was a lift type ruled out?

Each one lists its reason: a ceiling lower than the lift is tall, a slab thinner than the maker's minimum, concrete under 28 days old, a floor you can't drill, or vehicles heavier than the lift is built for.