Lift installation in London, from site check to handover
Before we quote a London install, we come out and look at the ceiling, the concrete and the power in your bay. We also install lifts that you bought somewhere else.
Taking whatever unit you can get
London's 2023 Industrial Land Development Strategy says vacancy in industrial buildings fell from 11.5% in 2010 to 0.6% in 2022. With space that tight, many shops sign for a unit that was never built for vehicle work.
That's fine, as long as the lift matches the building. A lift that suits a tall new plant in Innovation Park may not fit a low unit off Oxford Street East.
Height: old units and new rules
In 2017 the City raised the maximum height for all standard Light Industrial zones, because newer industrial processes need more room. In 2022 it removed a 15 metre cap in Innovation Park Phase IV so the standard limit applies there too.
Your existing unit was built under whatever rules applied when it went up. So we don't guess. We measure from the floor to the lowest thing above the lift, whether that's a light, a heater, a sprinkler line or an overhead door track.
If a clearfloor two-post is too tall, a baseplate two-post, a four-post or a low-rise lift may fit the job.
Concrete comes first
Each lift maker sets a minimum slab thickness and strength for its lifts. Heavier lifts often need more. We check that spec against your floor before any holes are drilled.
Working garages are hard on floors. London Transit's own report found the concrete floors in the maintenance and storage areas of its older Highbury buildings in poor condition. A floor in a unit that has held trucks or forklifts for decades deserves a close look.
Cracks, saw cuts, old repairs and drains near the post locations all change where a lift can go. If the slab won't hold anchors, a freestanding four-post, a mobile column lift or a new engineered pad can be the answer.
Leased units and the paperwork around a lift
If you lease, anchoring posts and adding a circuit are changes to someone else's building, so get your landlord's written OK early. We give you the lift's needs for slab, height and power to take to that meeting.
Our install scope does not cover building permits or electrical work. That is normal for this trade. We tell your electrician what the lift needs at the bay.
Installing a lift you already own
Bought a lift from another seller, or picked one up when a shop closed? We install lifts bought elsewhere. Send us the make, the model and the install manual, and we check them against your bay before we book the install.
If you haven't bought yet, send the spec sheet first. It's easier to rule out a lift on paper than after it's on your floor.
Ontario Regulation 851, section 51(1)(b), calls for a lifting device to be examined "prior to being used for the first time". We inspect lifts too, so the first exam can be booked with the install.
Common questions
Do you install lifts in London?
Yes. We come to your London shop, check the site, quote the install and put the lift in with our own crew. Call 416-771-0499 or ask for a quote to get started.
Can you put a lift in a leased London unit?
Yes, once your landlord agrees to the anchoring and any new wiring. We give you the lift's needs in writing so you can get that approval before you order.
Will you install a lift I bought somewhere else?
Yes. Send us the make, the model and the manual. We check that the lift suits your ceiling, slab and power, then book the install.
Do you handle permits and electrical?
No. Building permits and electrical work are outside our install scope, which is normal in this trade. We tell your electrician exactly what the lift needs.
What should I send before the site check?
The make and model if you have picked a lift, the vehicles you plan to lift, whether you own or lease, and a rough bay size. Photos of the ceiling and the floor where the lift will go help too.
Keep reading
Pricing a new lift?
Send your ceiling height and what you work on. You get one price for the lift, delivery and install.