Skip to content
Safe LiftSYSTEMS

Installing a lift in Burlington, from older QEW units to new 407 builds

We come to your Burlington unit and check the slab, the ceiling height and the power at the bay before we quote. We install the lifts we sell and lifts you bought somewhere else.

Two kinds of employment land

The Official Plan describes two very different sides of Burlington. The QEW Corridor holds smaller, scattered parcels and needs re-investment. The 407 Corridor is the newest Employment Area and is not fully built out, and Bronte Creek Meadows holds the city's biggest block of vacant employment land.

A lift headed for a decades-old unit and a lift headed for a new building run into different problems. We look at the building you actually have.

The Plan says the employment function of Bronte Creek Meadows is a priority for the City. Whatever gets built there, we check the slab and ceiling against the lift you want before we quote.

How we measure height

We don't go by the roof line. We measure from the floor to the lowest object above the lift's travel: a light fixture, a heater, a sprinkler head, or a door track with the door open.

A two-post with an overhead bar needs the most room. Under a lower ceiling, a baseplate two-post, a four-post or a low-rise lift can often do the same work.

What the concrete must carry

Each lift maker sets a minimum concrete thickness, and heavier lifts can need more. We check that number for the exact model before anyone drills an anchor hole.

A slab in an older unit may have been poured for storage and forklifts, not for anchors under a loaded lift. A new floor still needs checking against the lift's spec.

When a slab falls short, a freestanding four-post, a scissor lift or a new engineered pad is often the answer.

Leased units and what the land allows

Renting on Harvester Road or a service road? Get your landlord's written OK before anything is anchored or wired. We give you the slab, height and power needs so you can raise it early. We come to the unit to measure, so your landlord sees real numbers.

Check what your unit is zoned for before you sign. The 1997 Plan allows repair activities on General Employment land, but it also sets site-by-site rules, such as vehicle sales on the north side of Harvester Road west of Cumberland Avenue. Zoning for the exact unit is what counts.

Our install work leaves out building permits and electrical work, which is normal in this trade. We tell your electrician what the lift needs.

Lift bought from someone else

Bought a lift online, at auction or from a shop that closed? We install lifts bought elsewhere. Send the make, the model and the install manual if you have it. If you haven't paid yet, send the spec sheet first, so we can check it against your ceiling and slab.

Ontario Regulation 851, section 51(1)(b), says a lifting device shall "be thoroughly examined by a competent person to determine its capability of handling the maximum load as rated, (i) prior to being used for the first time". We inspect lifts too, so ask us to book that exam with the install.

Common questions

Can you put a lift in a leased Burlington unit?

Yes, once your landlord approves the anchors and any new wiring. We check the slab, ceiling and power first and give you the lift's needs in writing for that talk.

Will you install a lift I bought somewhere else?

Yes. Send us the make, model and manual if you have them. We check the lift against your bay and your slab before we book the install.

Do you handle the building permit or the electrical?

No. Our install work does not include building permits or electrical work, which is standard in this trade. We tell you and your electrician exactly what the lift needs.

My unit is in a new building near the 407. Is the slab automatically fine?

Not automatically. A new floor can still be thinner than a given lift's maker requires. We check the slab spec against the exact lift model before any anchors go in.

The ceiling in my older unit looks low. What are my options?

We measure usable height to the lowest thing over the bay. If a two-post with an overhead bar won't fit, a baseplate two-post, a four-post, a scissor or a low-rise lift may do the job.

Pricing a new lift?

Send your ceiling height and what you work on. You get one price for the lift, delivery and install.