Skip to content
Safe LiftSYSTEMS

Challenger lift locks not releasing, leaks and level problems

We sell, install and service Challenger lifts across Toronto and the GTA. Here is what usually causes the common Challenger problems, and what our technician does about them.

Lift stuck up, or dropping?

Keep everyone clear and don’t go under it. Call 416-771-0499.

Common Challenger lift problems

Challenger lift locks will not retract

What usually causes it

  • Lock release not activating properly, so the idler column lock stays engaged
  • Lock release cable or latch release out of adjustment

What we do

Keep everyone clear and do not go under the lift or the vehicle. Call us. Our technician checks the lock release in both columns, including the release cable and the lock parts, and repairs or replaces them before the lift goes back in use.

Challenger lift stops short of full rise or chatters

What usually causes it

  • Low hydraulic fluid level
  • Air in the cylinders

What we do

Our technician checks the fluid and the hydraulic system, clears the air to Challenger's instructions, and finds out why the fluid was low.

Challenger lift raises unevenly

What usually causes it

  • Worn synchronizer cables or sheaves
  • Synchronizer cables out of tension
  • Lift installed on an out-of-level floor

What we do

Our technician checks the synchronizer cables and sheaves for wear and tension. Challenger says the cables are always replaced in sets, so that is how we replace them.

Challenger lift leaking fluid or drifting down

What usually causes it

  • A leak in the hydraulic system
  • Debris in the check valve or lowering valve seat

What we do

Keep everyone clear and do not go under the lift or the vehicle. Call us. Our technician traces the leak or the valve letting the lift down, and repairs or replaces it.

Loose anchors or cracked concrete near a Challenger base plate

What usually causes it

  • Anchor bolts that have lost their torque
  • Cracks or spalls in the concrete close to the base plate
  • Floor too thin, or concrete not strong enough

What we do

Take the lift out of use and call us. Our technician checks the anchors and the concrete around each column, and tells you what the floor needs.

Challenger's manual calls for genuine Challenger Lifts parts for worn adapters, cables and sheaves. ANSI/ALI ALIS calls for parts approved by the manufacturer or built to its original specs.

Challenger lifts we see

Challenger two-post surface mounted lifts like the CL10, CL12A, CL16 and CL20, and heavier two-posts for box trucks and fleet vehicles.

We supply, install and service Challenger lifts.

Never override a lock to get it down

Challenger's manual says not to override any safety feature in an attempt to lower the lift. If the lift will not come off its locks, keep people clear and call us.

What to tell us when you call

A few details let the right person call you back ready.

  • Your shop address
  • The make and model of the lift, and the serial number if you can read it
  • What the lift is doing, or not doing
  • Whether a vehicle is on the lift, and whether it is up or down
  • Your last inspection or service record, if you have it

Inspecting Challenger lifts

Ontario requires every lift in your shop to be examined at least once a year, with a signed record.

We inspect Challenger lifts along with every other lift in the shop, in one visit. Anything that needs repair goes on the record in plain words.

Common questions

Do you sell Challenger lifts?

Yes. We supply, install and service Challenger lifts, including heavy two-posts for box trucks and fleet vehicles.

Can I get a Challenger lift down by bypassing the lock?

No. Challenger's manual says never to override any safety feature in an attempt to lower the lift. Keep people clear and call us.

Do you work on Challenger lifts you did not install?

Yes. We install, inspect and service lifts from pretty much any brand. Tell us the Challenger model and what the lift is doing.

What parts do you use on a Challenger repair?

ANSI/ALI ALIS, the North American standard for lift installation and service, says worn, damaged or broken parts are replaced with parts approved by the original manufacturer, or parts that meet the original manufacturer's specs. That is the rule we follow on Challenger lifts.

Lift down?

Call now. Tell us the make, the model and what it's doing, so the technician comes ready for that lift.