Skip to content
Safe LiftSYSTEMS

Warning signs that mean stop using the lift

If a lift starts doing something new, stop using it and call. This page lists the signs to watch for. It is not a repair guide.

Inspection and compliance / Checked

Stop first, then call

Don't run the lift again to see if it happens twice, and don't put anyone under a vehicle on it.

Put a clear sign on the lift and its controls so nobody uses it. Then call 416-771-0499.

How the lift moves

Any of these is a reason to stop and call.

  • It drifts or slowly comes down
  • It won't raise, or won't raise a load
  • The motor runs but the lift doesn't go up
  • It rises out of level
  • It makes a noise it didn't make before

Locks and controls

For hydraulic and pneumatic hoists, section 51(1)(e) of Regulation 851 says a lifting device shall "when it is a pneumatic or hydraulic hoist, have controls that automatically return to their neutral position when released".

  • Locks that won't engage
  • Locks that won't release
  • Controls that don't return to neutral when you let go

Leaks, wear and damage you can see

On that last point, section 51(1)(c) says a lifting device shall "be plainly marked with sufficient information so as to enable the operator of the device to determine the maximum rated load that the device is capable of lifting under any operating condition".

  • Oil leaks at cylinders, hoses or fittings
  • Oil that keeps disappearing from an in-ground lift
  • Cables, chains or sheaves that look worn or damaged
  • Anchors that are loose
  • Arms, restraints or pads that are damaged or don't hold
  • A rated load marking that is missing or can't be read

Why it's a job for a lift technician

Section 25(1)(b) of the Occupational Health and Safety Act says an employer shall ensure that "the equipment, materials and protective devices provided by the employer are maintained in good condition".

ANSI/ALI ALIS, the North American standard for lift installation and service, says worn or broken parts are replaced with parts approved by the manufacturer, or parts that meet its specs. It also says no lift is modified without the manufacturer's written permission.

What to tell us when you call

The right person needs these details when they call you back.

  • Your shop address
  • Make and model of the lift
  • What the lift is doing, or not doing
  • Whether a vehicle is on the lift, and whether it is up or down
  • The best number to reach you

Common questions

My lift is slowly drifting down. Can I keep using it?

Stop using it and call a lift technician. Mark the lift out of service so nobody works under it. Call 416-771-0499 with the make, model and whether a vehicle is on it.

Should I wait for the next annual inspection?

No. Regulation 851, section 51(1)(b), says a lift is examined "as often as necessary but not less frequently than recommended by the manufacturer and in any case, at least once a year". Once a year is the minimum. A warning sign between inspections is a reason to call now.

Can we fix it in-house with parts we have?

ANSI/ALI ALIS says worn, damaged or broken parts are replaced with parts approved by the lift's manufacturer, or parts that meet its specs, and that no lift is modified without the manufacturer's written permission. If the repair changes the power wiring, that part is done by or under a licensed electrician.

Do you repair lifts from any brand?

Yes. We repair and service vehicle lifts on pretty much any brand. Tell us the make and model and what the lift is doing.

Sticker running out?

Book your annual inspection. We inspect every lift in the shop in one visit, with a signed record for each.