Skip to content
Safe LiftSYSTEMS

Ministry of Labour inspections: what applies to your lifts

Shop hoists are a Ministry of Labour matter in Ontario, not a TSSA one. Here is what the Act lets an inspector do, and the parts of Regulation 851 that apply to lifting devices.

Inspection and compliance / Checked

Shop hoists are a Ministry of Labour matter

Regulation 851 defines a lifting device this way:

"'lifting device' means a device that is used to raise or lower any material or object and includes its rails and other supports but does not include a device to which Ontario Regulation 209/01 (Elevating Devices), made under the Technical Standards and Safety Act, 2000, applies"

Vehicle hoists in a repair shop are not covered by the elevating devices regulation, so they sit under Regulation 851 and the Ministry of Labour, Immigration, Training and Skills Development. Parking lifts and car stackers are different. Those are TSSA-regulated.

Why the Ministry says inspectors visit

The Ministry says its inspectors make proactive visits, including to "check that workplaces are following occupational health and safety legislation".

It says they make reactive visits "in response to a" fatality, critical injury, work refusal, complaint, occupational illness or "other health and safety related event in the workplace".

What the Act lets an inspector do

Section 54(1) of the Occupational Health and Safety Act lists an inspector's powers. These are the clauses closest to lifts and their paperwork. An inspector may:

  • "(a) subject to subsection (2), enter in or upon any workplace at any time without warrant or notice"
  • "(c) require the production of any drawings, specifications, licence, document, record or report, and inspect, examine and copy the same"
  • "(k) require in writing an employer to have equipment, machinery or devices tested, at the expense of the employer, by an engineer and to provide, at the expense of the employer, a report bearing the seal and signature of the engineer stating that the equipment, machine or device is not likely to endanger a worker"
  • "(l) require in writing that any equipment, machinery or device not be used pending testing described in clause (k)"

What Regulation 851 says about lifting devices

Section 51(1) says a lifting device shall, among other things:

(b) "be thoroughly examined by a competent person to determine its capability of handling the maximum load as rated, (i) prior to being used for the first time, and (ii) thereafter as often as necessary but not less frequently than recommended by the manufacturer and in any case, at least once a year, and a record shall be kept, signed by the competent person doing the examination"

(c) "be plainly marked with sufficient information so as to enable the operator of the device to determine the maximum rated load that the device is capable of lifting under any operating condition"

(e) "when it is a pneumatic or hydraulic hoist, have controls that automatically return to their neutral position when released"

Section 51(2)(a) says a lifting device shall be operated only by "(i) a competent person, or (ii) a worker being instructed who is accompanied by a competent person".

Section 25(1)(b) of the Act says an employer shall ensure that "the equipment, materials and protective devices provided by the employer are maintained in good condition".

What one past blitz reported

From January 15 to February 28, 2018, the Ministry ran a blitz on machine guarding and electrical hazards at industrial workplaces.

Its published results list 220 orders for failure to "thoroughly examine a lifting device [s. 51 (1)(b)]", which was 5.8% of the total orders and requirements issued. That is a record of one past blitz, not a forecast.

Keep the paperwork where you can find it

The simplest way to be ready for any visit is a file you can hand over. For each lift, that means the signed examination records, kept as section 51(1.1) describes.

For a newer lift, add the pre-start health and safety review report, or the documentation that establishes an exemption, as section 7(8) of Regulation 851 describes.

Common questions

Can a Ministry of Labour inspector enter my shop without notice?

Section 54(1) of the Occupational Health and Safety Act says an inspector may "(a) subject to subsection (2), enter in or upon any workplace at any time without warrant or notice". Subsection (2) deals with dwellings, not shops.

Can an inspector ask for my lift inspection records?

Section 54(1) says an inspector may "(c) require the production of any drawings, specifications, licence, document, record or report, and inspect, examine and copy the same". Regulation 851, section 51(1)(b), is the rule that asks for a signed record of each lift examination.

Can an inspector have my lift tested?

Section 54(1)(k) lets an inspector require in writing that an employer have equipment tested by an engineer, at the employer's expense, with a sealed report. Section 54(1)(l) lets an inspector require in writing that the equipment not be used pending that testing.

Does Ontario law require an ALI certified inspector?

No. Regulation 851 does not name ALI or any other certification. ALI's inspector program is the industry gold standard. Our inspections follow ANSI/ALI ALOIM:2020, the recognised standard for lift inspection in North America.

Sticker running out?

Book your annual inspection. We inspect every lift in the shop in one visit, with a signed record for each.