Hydraulic fluid leaking from a lift
Hydraulic fluid on the floor or on the lift can mean a leak in the system. Treat it as a reason to stop the lift, not a reason to top up and carry on.
Running and maintaining lifts / Checked
What a leak can mean
BendPak's 10AP manual says hydraulic fluid on the ground or on the lift could indicate a leak in the hydraulic system. The fluid can come from hoses, fittings, cylinders or the power unit, and where it shows up is not always where it starts.
A leak can also let a lift drift down. BendPak's scissor lift manuals warn that, although rare, fluid can leak from the cylinders and let the lift slowly lower if it is not on its safety locks. The manuals say to leave a lift only fully lowered or on its locks.
A lift that won't hold its height can have more than one cause, and a leak is only one of them. Finding which one is a job for a trained lift technician.
When to stop using the lift
The manuals are direct about this. Stop and call if you see any of the following:
- Fluid on the floor under the lift, or on the columns, hoses or power unit
- A lift that creeps down, or won't hold a height
- Wet, swollen, cracked or rubbed-through hoses
- The fluid level dropping between checks
What the manuals say to do
BendPak's 10AP manual says to shut down the equipment if a leak is detected. It also says that if a leak is the source of a spill, the lift is locked out to prevent use until the hydraulic system is repaired.
BendPak's XPR-12CL manual puts it more simply: if oil leakage is observed, call a local service representative. Its manuals also say not to operate the lift if maintenance issues are found, and to take it out of service instead.
If a vehicle is on the lift, keep everyone out from under it and call us. Tell us the vehicle is up when you call.
Keep hands away from a leak
BendPak's manual warns that a needle-like stream of hydraulic fluid, even at low pressure, can go through the skin of fingers, hands or arms. It can feel like a small bite or prick, but the manual says any fluid injected into the body is serious and could be life-threatening.
The manual says anyone with such a wound goes to hospital as an emergency, and the doctor is told what type of fluid was involved. It also says to keep all parts of the body away from suspected leaks. Its power unit can build pressure over 5,000 psi.
Why a leak isn't a top-up job
Adding fluid doesn't fix whatever let it out. BendPak's 10AP manual says it does not authorize field repair of its power units, and that adjusting the pressure relief valve in the field is not permitted.
The ANSI/ALI ALIS standard says repairs follow the manufacturer's recommendations and use parts approved by the original manufacturer or meeting its specifications. That is work for a trained repair technician.
In-ground lifts
On older in-ground lifts, the cylinder sits below the floor. A leak there may not show on the surface, and fluid can end up in the soil. ALIS lists oil that disappears over time among the symptoms linked to underground piping or casing. Newer cassette designs sit inside a sealed containment enclosure.
If an in-ground lift is losing fluid, stop using it and call.
What to tell us when you call
We handle emergency lift calls across the GTA, Peel, Durham and Halton, and a person from our team gets back to you. Call 416-771-0499.
- The shop's location
- Make and model of the lift
- Where you see fluid, and roughly how much
- Whether the lift holds its height
- Whether a vehicle is on the lift
Common questions
Is it safe to keep using a lift that's leaking a little?
No. BendPak's manual says to shut down the equipment if a leak is detected, and to lock out the lift to prevent use until the hydraulic system is repaired. A small leak is still a reason to stop and call.
My lift slowly drifts down. Is that a leak?
It can be. BendPak's manuals warn that fluid leaking from the cylinders can let a lift slowly lower if it is not on its safety locks. Other faults can cause it too. Stop using the lift, keep people out from under it, and call a lift technician.
Can I just add hydraulic fluid and keep going?
Adding fluid doesn't fix a leak. BendPak's manual says a lift with a leak is locked out until the hydraulic system is repaired, and that field repair of its power units is not authorized. Call us instead.
Do you handle emergency lift calls?
Yes. We handle emergency lift calls across the GTA, Peel, Durham and Halton. Call 416-771-0499 with your location, the lift's make and model and what it is doing, and a person from our team will get back to you.
Where this comes in
Lift down?
Call now. Tell us the make, the model and what it's doing, so the technician comes ready for that lift.