Skip to content
Safe LiftSYSTEMS

Direct Lift and Dannmar lifts that won't raise, lower or run smooth

We sell, install and service Direct Lift home and light commercial lifts across the GTA, and we repair and inspect Dannmar lifts too.

Lift stuck up, or dropping?

Keep everyone clear and don’t go under it. Call 416-771-0499.

Common Direct Lift and Dannmar lift problems

Direct Lift Pro Park will not raise off its latches

What usually causes it

  • Motor, pump or cylinder failure

What we do

Keep everyone clear and do not go under the lift or the vehicle. Call us. Our technician checks the motor, pump and cylinder, brings the lift down safely and repairs or replaces the failed part.

Pro Park motor runs but the lift will not rise

What usually causes it

  • Debris under the check valve
  • Clearance at the lowering handle plunger valve is off
  • Oil level too low

What we do

Our technician checks the power unit, valves and fluid, and repairs or replaces the failed part.

Dannmar two-post will not raise, or will not lower once raised

What usually causes it

  • Low hydraulic fluid
  • Air in the hydraulic system
  • A pinched or leaking hydraulic hose
  • No power, or wrong input voltage, at the power unit
  • A microswitch stuck on or shorted
  • Lift overloaded, or the load off balance

What we do

Keep everyone clear and do not go under the lift or the vehicle. Call us. Our technician checks the power supply, switches, power unit, fluid and hoses, brings the lift down safely and repairs the fault.

Jerky movement, or the vehicle sits out of level

What usually causes it

  • Air in the hydraulic system
  • On Dannmar two-posts: safety locks engaged at different heights

What we do

Do not work under a lift that is not level or not running smoothly. Our technician checks the hydraulics and lock engagement, and corrects the cause.

Pro Park leaks oil, or makes noise and vibrates

What usually causes it

  • Worn rod seal or piston seal in the cylinder
  • Oil level too high at the power unit tank
  • Cross beam ends rubbing the columns
  • A tight cylinder on a new lift

What we do

Our technician finds the leak or the source of the noise, rebuilds or replaces the cylinder if needed, and sets the cross beams to spec.

Worn, damaged or broken parts are replaced with parts approved by Direct Lift or Dannmar, or parts that meet their original specs, as ANSI/ALI ALIS calls for.

Dannmar is independent service

Independent service. We are not affiliated with Dannmar.

We repair and inspect Dannmar two-post and four-post lifts, working from Dannmar's own manuals.

Direct Lift and Dannmar lifts we see

Direct Lift makes Pro Park four-post lifts, two-posts like the Pro 9F and DL9, the Pro6MR scissor lift and ProCycle motorcycle lifts.

Dannmar makes two-post lifts like the D2-10 series, D2-12C and D2-15C, and four-post lifts like the D4-9.

What to tell us when you call

A few details let the right person call you back ready.

  • Your shop address
  • The make and model of the lift, and the serial number if you can read it
  • What the lift is doing, or not doing
  • Whether a vehicle is on the lift, and whether it is up or down
  • Your last inspection or service record, if you have it

Inspecting Direct Lift and Dannmar lifts

Ontario requires every lift in your shop to be examined at least once a year, with a signed record.

We inspect Direct Lift and Dannmar lifts along with every other lift in the shop, in one visit. Anything that needs repair goes on the record in plain words.

Common questions

Do you sell Direct Lift lifts?

Yes. We supply, install and service Direct Lift equipment, including Pro Park four-posts, two-posts, the Pro6MR scissor lift and ProCycle motorcycle lifts.

Are you a Dannmar dealer?

No. Dannmar work is independent service. We are not affiliated with Dannmar. We repair and inspect Dannmar lifts.

Can you install a Direct Lift I bought somewhere else?

Yes. We install, inspect and service lifts from pretty much any brand, including Direct Lift. Tell us the model, and one of our people will confirm the work with you.

What parts do you use on a Direct Lift or Dannmar repair?

ANSI/ALI ALIS, the North American standard for lift installation and service, says worn, damaged or broken parts are replaced with parts approved by the original manufacturer, or parts that meet the original manufacturer's specs. That is the rule we follow on Direct Lift or Dannmar lifts.

Lift down?

Call now. Tell us the make, the model and what it's doing, so the technician comes ready for that lift.